Standard unit supplied as a complete assembly pre-wired
and pre-plumbed ready for connecting to the hot and
cold water and power supplies and to the waste water
outlet.
Standard unit is supplied as a single station but
multiple units can be provided if required. Manufactured
in 304 grade stainless steel the back enclosure is
combined with a high quality washbasin with a rounded
front. The standard unit is supplied complete with
a 38mm waste fitting, chrome plated bottle trap,
sensor module, power pack, battery back up, low soap
detector probe, service panel, lockable front opening
door panel for the soap bottle and concealed wall
mounting bracket.
Operation
Wave hand across the red sensor disc and water will be dispensed from the larger
of the two nozzles to wet the hands first in line with correct hand washing
procedures. To stop initial flow of water and dispense soap cup hand in front
of the red sensor disc and below the smaller nozzle to activate the soap dispenser
lowering the cupped hand when suffient soap has been delivered. Wave hand across
the red sensor disc for water to be dispensed for the timed period. Repeat
process if further water or soap needs to be dispensed. The sensor disc detects
the presence of the hand at 60 mm. The timed supply of water is factory set
for 21 seconds but can be easily adjusted for 14 or 7 seconds if required.
Low Soap Detection
If the centre of the red sensor disc is flashing then the soap bottle needs
to be replaced. When low soap is detected the unit will only dispense four
more times to prevent the soap tubes being emptied. Once a new soap bottle
is fitted, dispensing will resume.
Green Power Light
If the green power light goes out then the power
supply has failed and the unit is on battery back
up, consult an engineer.
Sensor Module
Comprises a stainless steel front panel with a back
box for recessed mounting into the back box enclosure.
The chrome plated spout for the water and a smaller
stainless steel nozzle for the soap or antiseptic
solutions are mounted into the front panel.
The soap nozzle is removable so that it can be cleaned
and disinfected. A 25mm diameter dark red sensor
disk is also located on the front panel, which glows
red in the centre of the disc when activated.
The sensor module houses the spouts, sensor disc,
soap pump, solenoid valve PCB and the low soap warning
system. The sensor module is accessed from the front
for ease of maintenance.
Service Panel
The removable service panels are located beneath
the unit and concealed in the rear box section.
The service panel is easily lowered down from the
unit for service and maintenance.
The service panel houses the power pack, battery
back up and the thermostatic valve.
The wash station has its own sensor module, service
panel and front opening, lockable soap door for ease
of changing over bottles and positioning the low
soap detector probe back into the replacement bottle.
Features
The latest technology and easy to use.
No touch infrared sensor control for both soap and
water operations pre plumbed and pre wired ready
for installation. Thermostatic controlled water.
Lockable front opening door with clear operating
instructions inscribed on the front of the door.
Battery back up fitted as standard.
Installation
Connection to service panel (thermostatic
control valve) for 2 x 1/2 hot and cold water supply.
1 x 1mm2 3 core mains flex for connection
to 220/240
volt AC mains supply (via switch fused spur)
Adjust thermostatic valve to required
temperature (normally factory set at 43 degrees).
All the internal water and soap connections are pre-plumbed. The electrical 12 volt DC supply is also
pre-connected internally.
Optional Extras
• Stainless steel under shield
