Standard unit supplied as a complete assembly pre-wired
and pre-plumbed ready for connecting to the hot and cold
water and power supplies and to the waste water outlet.
Standard
unit is supplied as a single station but multiple units
can be provided if required. Manufactured in 304
grade stainless steel the back enclosure is combined
with a high quality washbasin with a rounded front.
The standard unit is supplied complete with a 38mm waste
fitting, chrome plated bottle trap, sensor module,
power
pack, battery back up, low soap detector probe, service
panel, lockable front opening door panel for the soap
bottle and concealed wall mounting bracket.
Operation
Wave hand across the red sensor disc and water will
be dispensed from the larger of the two nozzles to
wet the hands first in line with correct hand washing
procedures. To stop initial flow of water and dispense
soap cup hand in front of the red sensor disc and below
the smaller nozzle to activate the soap dispenser lowering
the cupped hand when suffient soap has been delivered.
Wave hand across the red sensor disc for water to be
dispensed for the timed period. Repeat process if further
water or soap needs to be dispensed. The sensor disc
detects the presence of the hand at 60 mm. The timed
supply of water is factory set for 21 seconds but can
be easily adjusted for 14 or 7 seconds if required.
Low Soap Detection
If the centre of the red sensor disc is flashing
then the soap bottle needs to be replaced.
When low soap is detected the unit will only
dispense four more times to prevent the soap
tubes being emptied. Once a new soap bottle
is fitted, dispensing will resume.
Green Power Light
If the green power light goes out then the power supply
has failed and the unit is on battery back up, consult
an engineer.
Sensor Module
Comprises a stainless steel front panel with a back
box for recessed mounting into the back box enclosure.
The
chrome plated spout for the water and a smaller stainless
steel nozzle for the soap or antiseptic solutions are
mounted into the front panel.
The soap nozzle is removable
so that it can be cleaned and disinfected. A 25mm diameter
dark red sensor disk
is also located on the front panel, which glows red
in the centre of the disc when activated.
The sensor module houses the spouts,
sensor disc, soap pump, solenoid valve PCB and the
low soap warning
system. The sensor module is accessed from the
front for ease of maintenance.
Service Panel
The removable service panels are located beneath the
unit and concealed in the rear box section.
The service panel is easily lowered down from the unit
for service and maintenance.
The service panel houses
the power pack, battery back up and the thermostatic
valve.
The wash station has its own sensor module, service
panel and front opening, lockable soap door for ease
of changing over bottles and positioning the low soap
detector probe back into the replacement bottle.
Features
The latest technology and easy to use. No touch infrared
sensor control for both soap and water operations pre
plumbed and pre wired ready for installation. Thermostatic
controlled water. Lockable front opening door with clear
operating instructions inscribed on the front of the
door. Battery back up fitted as standard.
Installation
Connection to service panel (thermostatic control
valve) for 2 x 1/2 hot and cold water supply. 1 x 1mm2 3 core mains flex for
connection to 220/240 volt AC
mains supply (via switch fused spur)
Adjust thermostatic valve to required temperature (normally
factory set at 43 degrees). All the internal water and
soap connections are pre-plumbed. The electrical 12 volt
DC supply is also pre-connected internally.
Optional Extras
• Stainless steel under shield
